Running cudaHashcat-1.33 on AWS g2.2xlarge - Error cuModuleLoad() 209 when trying cudaExample0.sh

as it says in the description I have installed cudaHashcat-1.33 on an AWS g2.2xlarge instance.

I've used the .run file to install the CUDA Toolkit and then performed this test: deviceQuery ; as explained here in the official documentation (http://ift.tt/1ADD1td).

Then I installed cudaHashcat-1.33, following these instructions.

sudo apt-get install p7zip-full
wget http://ift.tt/1BE86m1
7za x cudaHashcat-1.33.7z
cd cudaHashcat-1.33

Then I tried to run this: cudaExample0.sh in ~/cudaHashcat-1.33/cudaExample0.sh and I end up getting this output:

cudaHashcat v1.33 starting...

Device #1: GRID K520, 4095MB, 797Mhz, 8MCU
Device #1: WARNING! Kernel exec timeout is not disabled, it might cause you errors of code 702

Hashes: 6494 hashes; 6494 unique digests, 1 unique salts
Bitmaps: 16 bits, 65536 entries, 0x0000ffff mask, 262144 bytes
Applicable Optimizers:
* Zero-Byte
* Precompute-Init
* Precompute-Merkle-Demgard
* Meet-In-The-Middle
* Early-Skip
* Not-Salted
* Not-Iterated
* Single-Salt
* Scalar-Mode
* Raw-Hash
Watchdog: Temperature abort trigger set to 90c
Watchdog: Temperature retain trigger set to 80c


ERROR: cuModuleLoad() 209

If someone knows what the fuck is going on, I'd appreciate any help.

Kind Regards, Adrian